DGS-3000 Series Layer 2 Managed Gigabit Ethernet Switch CLI Reference Guide
461
DGS-3000-26TC:admin#show jwac ports 1-4
Command: show jwac ports 1-4
Port State Aging Time Idle Time Block Time Auth Mode Max
(min) (min) (sec) Hosts
----- -------- ---------- --------- ---------- ---------- -----
1 Enabled 1440 Infinite 60 Host-based 50
2 Enabled 1440 Infinite 60 Host-based 50
3 Enabled 1440 Infinite 60 Host-based 50
4 Enabled 1440 Infinite 60 Host-based 50
DGS-3000-26TC:admin#
config jwac radius_protocol
42-20
Description
This command is used to specify the RADIUS protocol used by JWAC to complete RADIUS
authentication.
JWAC shares other RADIUS configurations with 802.1X. When using this command to set the
RADIUS protocol, make sure the RADIUS server added by the
config radius
command supports
the protocol.
Format
config jwac radius_protocol [local | eap_md5 | pap | chap | ms_chap | ms_chapv2]
Parameters
local
- Specify the JWAC switch uses the local user DB to complete the authentication.
eap_md5
- Specify the JWAC switch uses EAP MD5 to communicate with the RADIUS server.
pap
- Specify the JWAC switch uses PAP to communicate with the RADIUS server.
chap
- Specify the JWAC switch uses CHAP to communicate with the RADIUS server.
ms_chap
- Specify the JWAC switch uses MS-CHAP to communicate with the RADIUS server.
ms_chapv2
- Specify the JWAC switch uses MS-CHAPv2 to communicate with the RADIUS
server.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To configure the RADIUS protocol used by JWAC:
DGS-3000-26TC:admin#config jwac radius_protocol ms_chapv2
Command: config jwac radius_protocol ms_chapv2
Success.
DGS-3000-26TC:admin#
Summary of Contents for DGS-3000 series
Page 1: ......