DGS-3000 Series Layer 2 Managed Gigabit Ethernet Switch CLI Reference Guide
338
sub-ring.
state
- Specify the propagation state of the topology change for the sub-ring.
enable
- Enable the propagation state of the topology change for the sub-ring.
disable
- Disable the propagation state of the topology change for the sub-ring.
add
- Specify the add a topology change propagation rule.
delete
- Specify to delete a topology change propagation rule.
sub_ring
- Specify the sub-ring configuration information.
raps_vlan
- Specify the R-APS VLAN.
<vlanid>
- Enter the R-APS VLAN ID used here
revertive
- Specify the state of the R-APS revertive option.
enable
- Specify that the R-APS revertive option will be enabled.
disable
- Specify that the R-APS revertive option will be disabled.
timer
- Specify the R-APS timer used.
holdoff_time
- Specify the holdoff time of the R-APS function. The default holdoff time is 0
milliseconds.
<millisecond 0-10000>
- Enter the hold off time value here. This value must be in the
range of 0 to 10000 millseconds.
guard_time
- Specify the guard time of the R-APS function. The default guard time is 500
milliseconds.
<millisecond 10-2000>
- Enter the guard time value here. This value must be in the range
of 0 to 2000 millseconds.
wtr_time
- Specify the WTR time of the R-APS function.
<min 5
-
12>
- Enter the WTR time range value here. The range is from 5 to 12 minutes.
The default WTR time is 5 minutes.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To configure the MEL of the ERPS ring for a specific R-APS VLAN:
DGS-3000-26TC:admin#config erps raps_vlan 4094 ring_mel 2
Command: config erps raps_vlan 4094 ring_mel 2
Success.
DGS-3000-26TC:admin#
To set the R-APS east ring port parameter to 7:
DGS-3000-26TC:admin#config erps raps_vlan 4094 ring_port east 7
Command: config erps raps_vlan 4094 ring_port east 7
Success.
DGS-3000-26TC:admin#
To configure the RPL port for a specific R-APS VLAN:
Summary of Contents for DGS-3000 series
Page 1: ......
