DGS-3000 Series Layer 2 Managed Gigabit Ethernet Switch CLI Reference Guide
311
Chapter 25
Digital Diagnostic
Monitoring (DDM) Command
List
config ddm
[trap | log] [enable | disable]
config ddm ports
[<portlist> | all] [[temperature_threshold {high_alarm <degrees> | low_alarm
<degrees> | high_warning<degrees> | low_warning <degrees>}(1) | voltage_threshold
{high_alarm <voltage> | low_alarm<voltage> | high_warning<voltage> |
low_warning<voltage>}(1) | bias_current_threshold {high_alarm <milliampere> | low_alarm
<milliampere> | high_warning <milliampere> | low_warning<milliampere>}(1) |
tx_power_threshold {high_alarm <mw_or_dbm> | low_alarm <mw_or_dbm> | high_warning
<mw_or_dbm> | low_warning <mw_or_dbm>}(1) | rx_power_threshold {high_alarm
<mw_or_dbm> | low_alarm <mw_or_dbm> | high_warning <mw_or_dbm> | low_warning
<mw_or_dbm>}(1)] | {state [enable | disable] | shutdown [alarm | warning | none]}(1) |
reload_threshold]
show ddm
show ddm ports
{<portlist>} [status | configuration]
config ddm power_unit
[mw | dbm]
config ddm
25-1
Description
This command is used to configures the DDM log and trap action when encountering an exceeding
alarm or warning thresholds event.
Format
config ddm [trap | log] [enable | disable]
Parameters
trap
- Specify whether to send traps, when the operating parameter exceeds the corresponding
threshold. The DDM trap is disabled by default.
log
- Specify whether to send a log, when the operating parameter exceeds the corresponding
threshold. The DDM log is enabled by default.
enable
- Specify to enable the log or trap sending option.
disable
- Specify to disable the log or trap sending option.
Restrictions
Only Administrators and Operators can issue this command.
Example
To configure DDM log state to enable:
Summary of Contents for DGS-3000 series
Page 1: ......