DGS-3000 Series Layer 2 Managed Gigabit Ethernet Switch CLI Reference Guide
198
Chapter 18
Debug Software Command
List
debug error_log
[dump | clear | upload_toTFTP {<ipaddr> <path_filename 64>}]
debug buffer
[utilization | dump | clear | upload_toTFTP <ipaddr> <path_filename 64>]
debug output
[module <module_list> | all] [buffer | console]
debug config error_reboot
[enable | disable]
debug config state
[enable | disable]
debug show error_reboot state
debug show status
{module <module_list>}
debug dhcpv6_relay hop_count state
[enable | disable]
debug dhcpv6_relay output
[buffer | console]
debug dhcpv6_relay packet
[all | receiving | sending] state [enable | disable]
debug dhcpv6_relay state disable
debug dhcpv6_relay state enable
debug dhcpv6_server packet
[all | receiving | sending] state [enable | disable]
debug dhcpv6_server state disable
debug dhcpv6_server state enable
debug error_log
18-1
Description
This command is used to dump, clear or upload the software error log to a TFTP server.
Format
debug error_log [dump | clear | upload_toTFTP {<ipaddr> <path_filename 64>}]
Parameters
dump
- Displays the debug message of the debug log.
clear
- Clears the debug log.
upload_toTFTP
- Specify to upload the debug log to a TFTP server specified by IP address.
<ipaddr>
- (Optional) Enter the IPv4 address of the TFTP server.
<path_filename 64>
- (Optional) Enter the DOS pathname on the TFTP server. It can be a
relative pathname or an absolute pathname. This value can be up to 64 characters long.
Restrictions
Only Administrators can issue this command.
Example
To dump the error log:
Summary of Contents for DGS-3000 series
Page 1: ......