DGS-3000 Series Layer 2 Managed Gigabit Ethernet Switch CLI Reference Guide
558
<ipv6addr>
- Enter the multicast group IP address.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To delete an MLD snooping static group for VLAN 1, group FF1E::1:
DGS-3000-26TC:admin#delete mld_snooping static_group vlan default FF1E::1
Command: delete mld_snooping static_group vlan default FF1E::1
Success.
DGS-3000-26TC:admin#
config mld_snooping static_group
52-13
Description
This command is used to configure an MLD snooping multicast group static member port. When a
port is configured as a static member port, the MLD protocol will not operate on this port. For
example, suppose that a port is a dynamic member port learned by MLD. If this port is configured
as a static member later, then the MLD protocol will stop operating on this port. The MLD protocol
will resume once this port is removed from static member ports.
Format
config mld_snooping static_group [vlan <vlan_name 32> | vlanid <vlanid_list>] <ipv6addr>
[add | delete] <portlist>
Parameters
vlan
- Specify the name of the VLAN on which the static group resides.
<vlan_name 32>
- Enter the VLAN name here. The VLAN name can be up to 32 characters
long.
vlanid
- Specify the ID of the VLAN on which the static group resides.
<vlanid_list>
- Enter the VLAN ID list here.
<ipv6addr>
- Enter the multicast group IPv6 address.
add
- Specify to add the member ports.
delete
- Specify to delete the member ports.
<portlist>
- Enter a range of ports to be configured.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To unset port range 9-10 from MLD snooping static member ports for group FF1E::1 on default
VLAN:
Summary of Contents for DGS-3000 series
Page 1: ......