MENu ADDRESS
SETTINGS DESCRIPTION
INFORMATION
PRODuCT
Control Panel >
Network >
DATA PORT
BAuD RATE, PARITy, DATA BITS, STOP BITS
The system provides 1 - 2 standard RS232 serial ports to allow a computer to be connected for data
transfer and control purposes.
Note! When connecting to a PC, the connecting cable must be a straight through RS232 cable.
Configure the settings as required for your application:
Baud Rate (bps): 1200 - 115200
Parity: None, Odd, Even
Databits: 7, 8
Stopbits: 1, 2
A successfully connection of a PC to Data Port 1 requires
that the PC and the system are identically configured.
The control interface provided by the Data Port supports
a subset of the Hayes command set, as well as a
comprehensive set of system specific commands.
It maintains communication with the Data Port’s command
interpreter at all times. All features available from the hand-
held remote control can be accessed through the Data Port.
6000
3000
1700
95/75
Control Panel >
Network >
DATA PORT
DATA PORT MODE
CONTROL:
Gives command access, with the same interface as telnet or ssh. This is the default mode.
TRANSPARENT:
Line based text interface to far end in point to point call. The far end must also have
transparent mode enabled.
DIRECT:
Raw data interface to far end in point to point call. The far end must also have direct mode
enabled. Any data received on the local serial port is transmitted without change to the far end serial
port.
OFF:
Turns the data port Off.
Control Panel >
Network >
DATA PORT 2
DATA PORT 2 SETTINGS AND MODE
Data port 2 is dedicated to the main camera and will not be available in standard configuration.
The system will automatically detect PrecisionHD Camera and WAVE camera. At least one of the
cameras must be connected to the data port 2. All communications settings, except the Mode setting,
are automatically configured. Exception: If Mode is Auto and no camera is connected to the Data port 2,
the Baud rate, Parity, Data bits and Stop bits settings will be enabled.
VISCA:
Select VISCA mode if the camera support the VISCA protocol.
AuTO:
Select Auto and the system will automatically detect the PrecisionHD Camera or WAVE cameras.
VISCA™ is a trademark of Sony Corporation
6000
Control Panel >
Network >
CAMERA PORT
CAMERA PORT MODE
The Camera Port can be used by both PrecisionHD Camera and Wave II Camera.
VISCA:
Select VISCA mode if the camera support the VISCA protocol.
AuTO:
Select Auto and the system will automatically detect the PrecisionHD Camera or WAVE cameras.
VISCA™ is a trademark of Sony Corporation
3000
Control Panel >
Installation >
VIEW DEFAuLT SETTINGS
When you press “View Default Settings” you will see an overview of all default system setting values.
Use arrow up/down on the remote control to move up/down in the list.
All
86
Cisco TelePresence MXP Series
Administrator guide
D14791.01 MXP Series Administrator Guide F90, August
2011.
Copyright © 2010-2011 Cisco Systems, Inc. All rights reserved.
www.cisco.com
Contents
Contact us
Introduction
The menu structure
The settings library
Getting started
Appendices
The settings library
