Configure the Video system
To configure the video system go to Control Panel > Network >
ISDN/External/Leased E1/T1 and:
•
Set Network Type to
ISDN-BRI
•
Set the ISDN Switch Type to
National ISDN
Go to
Line 1 Setup
:
•
Enable Line 1, set to On
•
NUMBER1
: enter the number from the first SW56 line
•
NUMBER2
: enter the number from the second SW56 line
•
SPID1
: enter the number from the first SW56 line
•
SPID2
: Leave blank
•
Disable unused lines.
Check if you need to configure the
Advanced ISDN Settings
.
Connecting the System,
continued..
Connecting to Switched 56k Network
using Telesync TS-256 SW56/ISDN adapter
This page describes how to connect the system to a SW56
network using a Telesync Adapter.
There are different Telesync Adapters for different configurations of
SW56 networks.
The network types tested with the system are SW56 2Wire and
4Wire.
Connecting Cables
Connect the video system ISDN1 cable to the BRI S/T interface on
the Telesync Adapter.
Connect the two SW56 cables from the Telesync adapter Line 1
and Line 2 to the SW56 network.
Setting up a call
Go to the
Call Menu
and select
Make a Call
•
In the Call Menu, open
Default Call Settings
•
Set
Net
to
ISDN
•
Set
Bandwidth
to
128 kbps
•
A field for the 2nd ISDN number will pop up in
Call Settings
.
Enter the second ISDN number in the
Number2
field.
•
Set
Restrict (56k)
to
On
.
•
To use these settings for this call only, select the
OK
button.
To save the settings as your new Default Call Settings select
Set as Default
before pressing the
OK
button.
•
Go on with your call and enter the number to be dialed.
106
Cisco TelePresence MXP Series
Administrator guide
D14791.01 MXP Series Administrator Guide F90, August
2011.
Copyright © 2010-2011 Cisco Systems, Inc. All rights reserved.
www.cisco.com
Contents
Contact us
Introduction
The menu structure
The settings library
Getting started
Appendices
Appendices
