MENu ADDRESS
SETTINGS DESCRIPTION
INFORMATION
PRODuCT
Control Panel >
Audio >
LEVEL SETTINGS
LINE IN LEFT, LINE IN RIGHT
Level Settings lets you set each level independently. Adjust the input level setting to match the output
level of the unit you are connecting to the line inputs. The input level should be adjusted so that the
average level reaches within the yellow area, preferably in the middle.
LINE IN LEFT:
Set the audio input level for Line in Left.
LINE IN RIGHT:
Set the audio input level for Line in Right.
Since the TANDBERG 1700 MXP unit has built-in microphones and loudspeakers, the level settings apply
to Line Level Inputs and the headset loudspeakers/microphone only.
NOTE!
When you use the volume control, it may look like
you are able set the volume higher than the level specified
here (gain, and not just attenuation). However, a limiter is
used to ensure that low levels are amplified, while high
and potentially damaging levels will be limited so that the
maximum level as specified here will not be exceeded. A
compression will thus occur at higher levels.
See
Interfaces
in the
Peripheral Equipment
section for more
information on this topic for your product.
1700
Control Panel >
Audio >
LEVEL SETTINGS
HEADSET MIC, HEADSET OuT
It is possible to adjust the headset microphone input level according to the sensitivity of the used
headset. The on-screen audio level indicator will make it easier to set the correct input level settings.
The input level should be adjusted so that the average level reaches within the yellow area, preferably in
the middle. The headset microphone input level are adjustable in steps of 1.5 dB from 0 dB to 22.5 dB.
It is possible to adjust the audio output level to the headset loudspeakers.
HEADSET MIC:
Set the audio input level for the headset microphone. Default level is 3 dB.
HEADSET OuT:
Set the audio output level for the headset loudspeakers. Default level is 13.5 dB
TANDBERG 1000 MXP: Activate the headset by pressing the button in front, located below the
TANDBERG logo. Deactivate the headset by pressing the button once more.
Since the TANDBERG 1700 MXP unit has built-in microphones and loudspeakers, the level settings apply
to Line Level Inputs and the headset loudspeakers/microphone only.
The TANDBERG 1700/1000/Compass/Utility MXP have separate volume settings for loudspeaker and
headset output. The volume keys on the remote control also adjust the level of the headset output when
the headset is activated by pressing the push-button, without changing the volume setting you have
for the loudspeaker. When changing back to the loudspeaker, you will get the volume settings you had
before you activated the headset.
NOTE!
When you use the volume control, it may look like
you are able set the volume higher than the level specified
here (gain, and not just attenuation). However, a limiter is
used to ensure that low levels are amplified, while high
and potentially damaging levels will be limited so that the
maximum level as specified here will not be exceeded. A
compression will thus occur at higher levels.
See
Interfaces
in the
Peripheral Equipment
section for more
information on this topic for your product.
1700
1000
55
Cisco TelePresence MXP Series
Administrator guide
D14791.01 MXP Series Administrator Guide F90, August
2011.
Copyright © 2010-2011 Cisco Systems, Inc. All rights reserved.
www.cisco.com
Contents
Contact us
Introduction
The menu structure
The settings library
Getting started
Appendices
The settings library
