Configure the Video system
To configure the video system go to Control Panel > Network >
ISDN/External/Leased E1/T1 and:
•
Set Network Type to
ISDN-PRI
Then go to ISDN-PRI Settings:
•
Specify
Number Range
•
Specify
ISDN-PRI Switch Type
•
Configure the
Channel Hunting
settings.
•
Configure the
Line Settings
. (should correspond to the Cable
Length setting on the Adtran system).
•
Configure the
Advanced ISDN Settings
•
Configure the
Advanced ISDN-PRI Settings
Configure the Adtran T1 ESF CSu ACE
From the display on the unit:
•
Enter
2)CONFIG
menu using SCROLL and ENTER buttons.
•
Enter
3)TERMINAL
menu and check
1)FORMAT:ESF
,
2)CODE:
B8ZS
,
3)SET LBO: 0-133
(should correspond to the Cable
Length setting on the video system).
Go to Menu and enter
1)NETWORK
menu. Set
7)SET LBO: 0.0
(according to information from Telco).
Also, other network parameters should be set, according to
information from your Telco.
Connecting the System,
continued..
Connecting to PRI/T1
(ISDN-PRI is not available on all Cisco systems)
using a CSu (Channel Service unit) adapter
Connecting the system to the ISDN network via the E1/T1-interface
using an Adtran T1 ESF CSU ACE or equivalent CSU, will allow up
to 1.54 Mbps connection.
The E1/T1-interface must be connected to a CSU approved
according to IEC 60950, UL 1950 or equivalent standard.
The PRI-line will run the AT&T 4ESS, 5ESS and National ISDN
protocols in addition to Euro ISDN (E1).
Connecting to Adtran T1 ESF CSu ACE
Connect the PRI cable from the video system (codec) to the input
marked CPE (Customer Provided Equipment) on the Adtran CSU (a
straight through category 5 cable is recommended).
Connect to the network via the NET connector on the Adtran CSU.
Setting up a call
Go to the
Call Menu
and select
Make a Call
•
In the Call Menu, open
Default Call Settings
•
Set
Net
to
ISDN
•
To use these settings for this call only, select the
OK
button.
To save the settings as your new Default Call Settings select
Set as Default
before pressing the
OK
button.
•
Go on with your call and enter the number to be dialed.
105
Cisco TelePresence MXP Series
Administrator guide
D14791.01 MXP Series Administrator Guide F90, August
2011.
Copyright © 2010-2011 Cisco Systems, Inc. All rights reserved.
www.cisco.com
Contents
Contact us
Introduction
The menu structure
The settings library
Getting started
Appendices
Appendices
