Video Input
•
1 x VGA/DVI-I (DVI = Digital Visual Interface, I = Integrated
Digital & Analog) input, analog or digital.
VGA formats supported on DVI-I in
•
SVGA (800x600) 60Hz, 72Hz, 75Hz, 85Hz
•
XGA (1024x768) 60 Hz, 70Hz, 75Hz
•
SXGA (1280x1024) 60Hz
•
HD720p (1280x720) 50 Hz, 60 Hz
Read more
Read more about the DVI (Digital Visual Interface) and DVI Cables
in the beginning of the Peripheral Equipment section.
Go to
The Digital Visual Interface (DVI)
Go to
DVI Cables - The VGA to DVI
Go to
DVI Cables - The VGA to DVI-A
Headset
The unit has a built-in headset connector, 2.5mm 3-pole mini-
jack.
The headset plug must have the following configuration:
•
Tip: microphone output
•
Ring: earphone (receiver input)
•
Sleeve: common/ground
All audio inputs are active by default. For further information,
refer to chapter Audio.
INFO:
Headsets with the microphone positioned in front of the
user’s mouth, connected to the earphone through a rod, tend
to give more echo than earbud headsets with the microphone
attached to the cord. The Plantronics MX100 headset can be
used (
, products mobile).
Activate the headset by pressing the button in front, located
below of the TANDBERG logo. Deactivate the headset by
pressing the button once more.
Microphone
The microphone is integrated and located at the edge on the left
hand side of the unit.
Ethernet
The unit has 1 x Ethernet (Rj-45 jack) LAN interface (10/100
Mb) up to 768kbps
To connect the system to a LAN, use the Ethernet cable provided
by Cisco (or a standard Ethernet cable). If no LAN is available and
the codec is connected directly to a computer, use a crossover
cable.
If no DHCP server is controlling the small LAN, which has been
created between the computer and the video system, then static
TCP/IP settings must be used. When configuring a back-to-back
connection between the PC and the video system, make sure
both static IP addresses exist on the same subnet.
ISDN BRI Interface:
The unit has 3 x ISDN I.420 (Rj-45 jack) Basic Rate Interface
S/T (2B+D), 128 kbps per ISDN I/F
To connect the system to BRI, use the ISDN cable provided by
Cisco (or a standard BRI cable). The pinout of the S/T interface
is:
Ethernet cable
1
-----
1
2
-----
2
3
-----
3
6
-----
6
1
1
2
2
3
3
6
6
Wiring diagram
standard cable
Wiring diagram
crossover cable
S/T Interface
BRI
Pin out
Pin 3
TX+
Pin 4
RX+
Pin 5
RX–
Pin 6
TX–
Rj-45 Connector
pin-out
Rj-45 Connector
pin-out
1000 MXP, Compass/utility MXP Interfaces and sockets,
cont...
Video, Audio and Network
117
Cisco TelePresence MXP Series
Administrator guide
D14791.01 MXP Series Administrator Guide F90, August
2011.
Copyright © 2010-2011 Cisco Systems, Inc. All rights reserved.
www.cisco.com
Contents
Contact us
Introduction
The menu structure
The settings library
Getting started
Appendices
Appendices
