Bay Networks 5391, Manual, Page: 284 / 351

Managing Remote Access Concentrators Using Annex Manager
Appendix A RAC Parameters
A-94
speed defines the baud rate of the asynchronous line between a device and a RAC. The
value you enter must match the device baud rate. If you want line speed to be
determined automatically, use the
autobaud
parameter.
If you enter
disabled
in the autobaud parameter, you must enter a
value here.
Not all RACs support all port speeds. Refer to your RAC hardware
guides for detailed information.
stop_bits
specifies the number of stop bits for a port.
subnet_mask contains the RAC IP subnet mask. The subnet mask defines which portion of the
IP address is the network, subnet, and host. The parameter default is based on
the network portion of the RAC IP address. Setting this parameter incorrectly
can cause routing problems.
sysContact identifies the contact person for this managed node, including information on
how to contact this person.
Type Async
Values
2000, 2400, 3600, 4800, 7200, 9600, 19200, 38400, 57600,
115,200, and others
Default 9600
Lists
Async Port, Basic Async Port, Modem
Type
Async
Values one, two, one-and-half, dynamic
Default
one
Lists
Async Port, Basic Async Port, Modem, Modem Internal
Type RAC Only
Values
IP address
Default
0.0.0.0
Lists RAC Only, Basic RAC
Type
RAC
Default n/a
Values
0 to 255 characters
Lists
RAC Only