ACS contsys RCE 300, Manual

Page: 86 / 152

ACS-CONTROL-SYSTEM GmbH l Lauterbachstr. 57 l D-84307 Eggenfelden l www.acs-controlsystem.de l info@acs-controlsystem.de
86
Anhang Universal Data Manager
86
Description The analog inputs are scanned in a 100ms cycle. Dependent on the store cycle the selected
data is selected and stored from the scanned values.
Only visible if signal = current, voltage, resistance temperature detector, thermocouple,
frequency input or Modbus Slave (option)
Options Instantaneous value, Average, Minimum value, Maximum value, M Maximum
Factory setting Average
Pulse counter
Navigation Expert → Inputs → Universal inputs → Universal input x → Pulse counter
Direct access code: 220017-0xx
Examples: Universal input 1: 220017-000; Universal input 12: 220017-011
Description Please check if the pulse counter used is a fast or slow (up to a max. 25 Hz) counter. For
example if the number of state changes from a relay are to be monitored then you must
set up "up to 25Hz".
Only visible if signal = pulse counter
Options Up to 13kHz, Up to 25Hz
Factory setting Up to 13kHz
Pulse value
Navigation Expert → Inputs → Universal inputs → Universal input x → Pulse value
Direct access code: 220010-0xx
Examples: Universal input 1: 220010-000; Universal input 12: 220010-011
Description Factor, that when multiplied by the input signal results in the required physical value.
Example: 1 pulse equals 5 m 3 -> enter "5".
Only visible if signal = pulse counter
User entry Number, max. 8 digits
Factory setting 1
Decimal point
Navigation Expert → Inputs → Universal inputs → Universal input x → Decimal point
Direct access code: 220005-0xx
Examples: Universal input 1: 220005-000; Universal input 12: 220005-011
Description Number of places after decimal point for the display.
Only visible if signal ≠ switched off