ACS-CONTROL-SYSTEM GmbH
l Lauterbachstr. 57 l D-84307 Eggenfelden l www.acs-controlsystem.de l [email protected]
31
Universal Data Manager
Commissioning
31
9
Commissioning
9.1
Function check
Make sure that all post-connection checks have been carried out before putting your device
into operation:
• Checklist for "post-installation check", (→ 11).
• Checklist for "post-connection check" (→ 19).
9.2
Switching on the measuring device
Once the operating voltage is applied, the display lights up and the device is ready for
operation.
If you are commissioning the device for the first time, program the setup as described in
the following sections of the Operating Instructions.
If you are commissioning a device that is already configured or preset, the device starts
measuring immediately as defined in the settings. The values of the channels currently
activated are shown on the display.
Remove the protective film from the display as this would otherwise affect the
readability of the display.
9.3
Setting the operating language
The operating language can be set in the main menu. You can access the main menu by
pressing the Navigator during operation. "Sprache/Language" appears in the display. Press
the Navigator again to open the language selection. Turn the Navigator to select the
desired language, and press the Navigator to apply the language.
Use the "Back" function, which can be found at the bottom of each menu/submenu,
to move up a level in the menu structure.
To quit the menu immediately, press and hold "Back" (>3 sec.) in the Navigator. You
will return immediately to the measured value display.
9.4
Configuring the measuring device (Setup menu)
Access to the setup is released when the device leaves the factory and can be locked in
various ways e.g. by entering a 4-digit access code. When locked, basic settings can be
checked but not changed. You can also use a PC to commission or configure your device.
Device configuration options
• Setup directly at the device
• Setup via SD card or USB stick by transferring the parameters stored on it
• Setup via web server using Ethernet
• Setup via configuration software using USB interface or Ethernet
9.4.1
Setup directly at the device
You can access the main menu by pressing the Navigator during operation. Turn the
Navigator to navigate through the available menus. When the desired menu is displayed,
press the Navigator to open the menu.
