ACS-CONTROL-SYSTEM GmbH
l Lauterbachstr. 57 l D-84307 Eggenfelden l www.acs-controlsystem.de l [email protected]
32
Commissioning
Universal Data Manager
32
In the
"Setup"
menu and in the
"Advanced setup"
submenu, you will find the
most
important
settings for the device:
Parameter
Possible settings
Description
Change date/time
UTC time zone
dd.mm.yyyy hh:mm:ss
You can change the date and time here.
Advanced setup
Advanced settings for the device e.g. system settings,
inputs, outputs, communication, application etc.
System
Basic settings that are needed to operate the device,
(e.g. date/ time, security, memory management,
messages, etc.)
Inputs
Settings for analog and digital inputs.
Outputs
Settings only required if outputs (e.g. relays or
analog outputs) are to be used.
Communicati
on
Settings required if the USB, RS232/RS485 or
Ethernet interface of the device is to be used (PC
operation, serial data export, modem operation, etc.).
The different interfaces (USB, RS232/RS485,
Ethernet) can be operated in parallel. However,
simultaneous use of the RS232 and RS485
interface is not possible.
Application
Define different application-specific settings (e.g.
group settings, limit values etc.).
A detailed overview of all operating parameters can be found in the appendix at the
end of the Operating Instructions. (→ 67)
9.4.2
Setup via SD card or USB stick
Save the device settings (setup data) on an SD card or USB stick. This setup file can then be
imported into other devices.
Save setup:
The function used to save the setup files can be found in the main menu under
"Operation -> SD card (or USB stick) -> Save setup"
.
!
CAUTION
If the SD card or USB stick are removed directly:
Risk of data loss on SD card or USB stick
‣
To remove the SD card or the USB stick, always select
"Operation -> SD card (or USB
stick) -> Remove safely"
in the main menu!
Import new setup directly at the device:
The function used to load the setup data can be
found in the main menu under
"Operation -> SD card (or USB stick) -> Load setup"
.
Repeat these steps to configure additional units with this setup.
!
CAUTION
If the SD card is not removed, saving of the measurement data will commence after
approx. 5 minutes.
Measured values may be saved unintentionally on the SD card. However, the setup data
are still retained in the memory.
‣
Replace SD card on time!
9.4.3
Setup via web server
To configure the device via the web server, connect the device via Ethernet to your PC.
Please observe the information and communication settings for Ethernet and the web
server under (→ 29)
