3Com S7906E - Switch, Configuration Manual

Page: 847 / 2621

1-4
z
Configure an IP address for each interface, and make sure all nodes are reachable to one another.
Configuration Procedure
Follow these steps to configure the basic RIPng functions:
To do… Use the command… Remarks
Enter system view system-view ––
Create a RIPng process and
enter RIPng view
ripng [ process-id ]
Required
Not created by default
Return to system view quit —
Enter interface view
interface interface-type
interface-number
––
Enable RIPng on the interface
ripng process-id enable
Required
Disabled by default
If RIPng is not enabled on an interface, the interface will not send or receive any RIPng route.
Configuring RIPng Route Control
This section covers the following topics:
z
Configuring RIPng Route Summarization
z
Advertising a Default Route
z
Configuring a RIPng Route Filtering Policy
z
Configuring a Priority for RIPng
z
Configuring RIPng Route Redistribution
Before the configuration, accomplish the following tasks first:
z
Configure an IPv6 address on each interface, and make sure all nodes are reachable to one
another.
z
Configure RIPng basic functions
z
Define an IPv6 ACL before using it for route filtering. Refer to ACL Configuration in the Security
Volume for related information.
z
Define an IPv6 address prefix list before using it for route filtering. Refer to Routing Policy
Configuration in the IP Routing Volume for related information.
Configuring an Additional Routing Metric
An additional routing metric can be added to the metric of an inbound or outbound RIP route, namely,
the inbound and outbound additional metric.
The outbound additional metric is added to the metric of a sent route. The route’s metric in the routing
table is not changed.