3Com S7906E - Switch, Configuration Manual

Page: 870 / 2621

1-10
To do… Use the command… Remarks
Configure an OSPFv3
cost for the interface ospfv3 cost value
[ instance instance-id ]
Optional
By default, OSPFv3 computes an
interface’s cost according to its bandwidth.
The cost value defaults to 1 for VLAN
interfaces and defaults to 0 for loopback
interfaces.
Follow these steps to configure a bandwidth reference value:
To do… Use the command… Remarks
Enter system view system-view
—
Enter OSPFv3 view ospfv3 [ process-id ]
—
Configure a bandwidth
reference value
bandwidth-reference value
Optional
100 Mbps by default
Configuring the Maximum Number of OSPFv3 Load-balanced Routes
If multiple equal-cost routes to a destination are available, enabling load balancing among these routes
can improve link utilization.
Follow these steps to configure the maximum number of load-balanced routes:
To do… Use the command… Remarks
Enter system view system-view
—
Enter OSPFv3 view ospfv3 [ process-id ]
—
Specify the maximum number
of load-balanced routes maximum load-balancing
maximum
Optional
The value defaults to 8.
Configuring a Priority for OSPFv3
A router may run multiple routing protocols. The system assigns a priority for each protocol. When these
routing protocols find the same route, the route found by the protocol with the highest priority is
selected.
Follow these steps to configure a priority for OSPFv3:
To do… Use the command… Remarks
Enter system view system-view
—
Enter OSPFv3 view ospfv3 [ process-id ]
—