3Com S7906E - Switch, Configuration Manual

Page: 1722 / 2621

1-73
Fec : 2.2.2.2/32
Nexthop : 10.0.0.1
In-Label : 3
Out-Label : NULL
In-Interface : Vlan-interface2
Out-Interface : ----------
LspIndex : 2051
Tunnel ID : 0x430000e
LsrType : Exgress
Bypass In Use : Not Exists
BypassTunnel : Tunnel Index[---]
Mpls-Mtu : 1500
------------------------------------------------------------------
LSP Information: BGP LSP
------------------------------------------------------------------
No : 3
VrfIndex : vpn1
Fec : 192.168.1.0/24
Nexthop : 192.168.1.1
In-Label : 1024
Out-Label : NULL
In-Interface : ----------
Out-Interface : ----------
LspIndex : 8193
Tunnel ID : 0x0
LsrType : Egress
Outgoing Tunnel ID : 0x0
Label Operation : POP
Perform the
display interface tunnel
command on PE 1. You can see that traffic is being forwarded
along the CR-LSP of the TE tunnel.
[PE1] display interface tunnel 1
Tunnel1 current state: UP
Line protocol current state: UP
Description: Tunnel1 Interface
The Maximum Transmit Unit is 1500
Internet Address is 12.1.1.1/24 Primary
Encapsulation is TUNNEL, service-loopback-group not set
Tunnel source unknown, destination 3.3.3.3
Tunnel protocol/transport CR_LSP
Last 300 seconds input: 5 bytes/sec, 0 packets/sec
Last 300 seconds output: 5 bytes/sec, 0 packets/sec
34 packets input, 2856 bytes
0 input error
34 packets output, 2856 bytes
0 output error