3Com S7906E - Switch, Configuration Manual

Page: 1869 / 2621

1-50
z
Select Max Privilege for any AAA Client and set the privilege level to level 3. After these
configurations, the user needs to use the password enabpass when switching to level 1, level 2, or
level 3.
z
Select Use separate password and specify the password as enabpass .
Figure 1-15 Configure advanced attributes for the Telnet user
3) Verify the configuration
After the above configuration, the Telnet user should be able to telnet to the switch and use username
test@bbb and password aabbcc to enter the user interface of the switch, and access all level 0
commands.
<Switch> telnet 192.168.1.70
Trying 192.168.1.70 ...
Press CTRL+K to abort
Connected to 192.168.1.70 ...
******************************************************************************
* Copyright (c) 2004-2009 3Com Corp. and its licensors. All rights reserved. *
* This software is protected by copyright law and international treaties. *
* Without the prior written permission of 3Com Corporation and its licensors,*
* any reproduction republication, redistribution, decompiling, reverse *
* engineering is strictly prohibited. Any unauthorized use of this software *
* or any portion of it may result in severe civil and criminal penalties, and*
* will be prosecuted to the maximum extent possible under the applicable law.*
******************************************************************************
Login authentication