1-3
z
Configure the IP addresses for related interfaces
Configuration Procedure
Follow these steps to configure a static route:
To do…
Use the command…
Remarks
Enter system view
system-view
—
ip route-static dest-address
{
mask
|
mask-length
}
{
next-hop-address | interface-type interface-number
next-hop-address
|
vpn-instance
d-vpn-instance-name next-hop-address
}
track
track-entry-number
[
preference
preference-value
]
[
tag tag-value
] [
description description-text
]
Configure a static
route
ip route-static vpn-instance
s-vpn-instance-name&<1-6> dest-address
{
mask |
mask-length
} {
next-hop-address track
track-entry-number
[
public
] |
interface-type
interface-number next-hop-address
|
vpn-instance
d-vpn-instance-name next-hop-address track
track-entry-number
} [
preference
preference-value
] [
tag tag-value
] [
description
description-text
]
Required
By default,
preference
for
static routes is 60,
tag
is 0, and no
description
information is
configured.
Configure the default
preference for static
routes
ip route-static default-preference
default-preference-value
Optional
60 by default
z
When configuring a static route, the static route does not take effect if you specify the next hop
address first and then configure it as the IP address of a local interface, such as VLAN interface.
z
If you do not specify the preference when configuring a static route, the default preference will be
used. Reconfiguring the default preference applies only to newly created static routes.
z
You can flexibly control static routes by configuring tag values and using the tag values in the
routing policy.
z
If the destination IP address and mask are both configured as 0.0.0.0 with the
ip route-static
command, the route is the default route.
z
For detailed information about track, refer to
Track Configuration
in the
High Availability Volume
.
Configuring BFD for Static Routes
Bidirectional forwarding detection (BFD) provides a general-purpose, standard, medium- and
protocol-independent fast failure detection mechanism. It can uniformly and quickly detect the failures
of the bidirectional forwarding paths between two routers for protocols, such as routing protocols and
Multiprotocol Label Switching (MPLS). For details about BFD, refer to
BFD Configuration
in the
High
Availability Volume
.
Summary of Contents for S7906E - Switch
