3Com S7906E - Switch, Configuration Manual

Page: 1645 / 2621

1-24
[UPE] mpls l2vpn
# Configure the basic attributes of VPLS instance aaa, which uses LDP.
[UPE] vsi aaa static
[UPE-vsi-aaa] pwsignal ldp
[UPE-vsi-aaa-ldp] vsi-id 500
[UPE-vsi-aaa-ldp] peer 2.2.2.2 backup-peer 3.3.3.3
[UPE-vsi-aaa-ldp] dual-npe revertive wtr-time 1
[UPE-vsi-aaa-ldp] quit
[UPE-vsi-aaa] quit
# Configure interface VLAN-interface 12 and enable MPLS on the interface.
[UPE] interface vlan-interface 12
[UPE-Vlan-interface12] ip address 12.1.1.1 255.255.255.0
[UPE-Vlan-interface12] mpls
[UPE-Vlan-interface12] mpls ldp
[UPE-Vlan-interface12] quit
# Configure interface VLAN-interface 13 and enable MPLS on the interface.
[UPE] interface vlan-interface 13
[UPE-Vlan-interface13] ip address 13.1.1.1 255.255.255.0
[UPE-Vlan-interface13] mpls
[UPE-Vlan-interface13] mpls ldp
[UPE-Vlan-interface13] quit
# On the interface connected with CE 1, that is GigabitEthernet 2/0/1, create a service instance and
bind the L2VPN.
[UPE] interface gigabitethernet 2/0/1
[UPE-GigabitEthernet2/0/1] service-instance 1000
[UPE-GigabitEthernet2/0/1-srv1000] encapsulation s-vid 10
[UPE-GigabitEthernet2/0/1-srv1000] xconnect vsi aaa
[UPE-GigabitEthernet2/0/1-srv1000] quit
# On the interface connected with CE 2, that is, GigabitEthernet 2/0/2 create a service instance and
bind the L2VPN.
[UPE] interface gigabitethernet 2/0/2
[UPE-GigabitEthernet2/0/2] service-instance 1000
[UPE-GigabitEthernet2/0/2-srv1000] encapsulation s-vid 11
[UPE-GigabitEthernet2/0/2-srv1000] xconnect vsi aaa
[UPE-GigabitEthernet2/0/2-srv1000] quit
3) Configure NPE 1
# Configure MPLS basic capability.
<Sysname> system-view
[Sysname] sysname NPE1
[NPE1] interface loopback 0
[NPE1-LoopBack0] ip address 2.2.2.2 32
[NPE1-LoopBack0] quit
[NPE1] mpls lsr-id 2.2.2.2
[NPE1] mpls
[NPE1–mpls] quit