3Com S7906E - Switch, Configuration Manual

Page: 610 / 2621

1-12
To do… Use the command… Remarks
Enter RIP view
rip [ process-id ]
[ vpn-instance
vpn-instance-name ]
––
Configure a default metric for
redistributed routes
default cost value
Optional
The default metric of a
redistributed route is 0 by
default.
Redistribute routes from
another protocol
import-route protocol
[ process-id | all-processes |
allow-ibgp ] [ cost cost |
route-policy
route-policy-name
| tag tag ] *
Required
No redistribution is configured
by default.
Only active routes can be redistributed. You can use the display ip routing-table protocol command
to display route state information.
Configuring RIP Network Optimization
Complete the following tasks before configuring RIP network optimization:
z
Configure network addresses for interfaces, and make neighboring nodes reachable to each other;
z
Configure RIP basic functions.
Configuring RIP Timers
You can change the RIP network convergence speed by adjusting RIP timers.
Follow these steps to configure RIP timers:
To do… Use the command… Remarks
Enter system view system-view ––
Enter RIP view
rip [ process-id ]
[ vpn-instance
vpn-instance-name ]
––
Configure values for RIP timers
timers { garbage-collect
garbage-collect-value |
suppress suppress-value |
timeout timeout-value | update
update-value } *
Optional
The default update timer,
timeout timer, suppress timer,
and garbage-collect timer are
30s, 180s, 120s and 120s
respectively.