3Com S7906E - Switch, Configuration Manual

Page: 2510 / 2621

1-19
To do… Use the command… Remarks
Configure the destination
address for a test operation
destination ip ip-address
Required
By default, no destination IP
address is configured for a test
operation.
Configure the source IP
address of a probe request in a
test operation
source ip ip-address
Optional
By default, no source IP
address is specified.
The source IP address must be
that of an interface on the
device and the interface must
be up. Otherwise, the test will
fail.
Configure common optional
parameters
Refer to Configuring Optional
Parameters Common to an
NQA Test Group Optional
Configuring the Collaboration Function
Collaboration is implemented by establishing collaboration entries to monitor the detection results of the
current test group. If the number of consecutive probe failures reaches the threshold, the configured
action is triggered.
Follow these steps to configure the collaboration function:
To do… Use the command… Remarks
Enter system view system-view —
Enter NQA test group view
nqa entry admin-name
operation-tag
—
Enter test type view of the test
group
type { dhcp | dlsw | dns | ftp |
http | icmp-echo | snmp | tcp |
udp-echo }
The collaboration function is
not supported in UDP jitter
and voice tests.
Create a collaboration entry
reaction item-num
checked-element probe-fail
threshold-type consecutive
occurrences [ action-type
{ none | trigger-only } ]
Required
Not created by default.
Exit to system view quit —
Create a track entry and associate
it with the specified collaboration
entry of the NQA test group
track entry-number nqa entry
admin-name
operation-tag
reaction item-num
Required
Not created by default.
z
You cannot modify the content of a reaction entry using the reaction command after the
collaboration entry is created.
z
The collaboration function is not supported in a UDP jitter or voice test.