3Com S7906E - Switch, Configuration Manual

Page: 2133 / 2621

1-7
Configuring Member Ports for a Smart Link Group
You can configure member ports for a smart link group either in smart link group view or in interface view.
The configurations made in these two views have the same effect.
In smart link group view
Follow these steps to configure member ports for a smart link group in smart link group view:
To do… Use the command… Remarks
Enter system view system-view —
Create a smart link group and enter
smart link group view
smart-link group group-id —
Configure member ports for a smart link
group
port interface-type
interface-number { master |
slave }
Required
In interface view
Follow these steps to configure member ports for a smart link group in interface view:
To do… Use the command… Remarks
Enter system view system-view —
Enter Ethernet interface view or layer 2
aggregate interface view interface interface-type
interface-number
—
Configure member ports for a smart link
group port smart-link group group-id
{ master | slave }
Required
Configuring Role Preemption for a Smart Link Group
Follow these steps to configure role preemption for a smart link group:
To do… Use the command… Remarks
Enter system view
system-view
—
Create a smart link group and enter
smart link group view
smart-link group group-id —
Enable role preemption preemption mode role
Required
Disabled by default.
Configure the preemption delay preemption delay delay-time
Optional
1 second by default
The preemption delay configuration takes effect only after role preemption is enabled.