1-14
z
To configure an MBGP peer group, you need to enable the corresponding IPv4 BGP unicast peer
group in IPv4 MBGP address family view.
z
Before adding an MBGP peer to an MBGP peer group, you need to add the corresponding IPv4
unicast peer to the IPv4 BGP peer group.
Configuring MBGP Community
The community attribute can be advertised between MBGP peers in different ASs. Routers in the same
community share the same policy.
You can reference a route policy to modify the community attribute for routes sent to a peer. In addition,
you can define extended community attributes as needed.
Follow these steps to configure MBGP community:
To do…
Use the command…
Remarks
Enter system view
system-view
—
Enter BGP view
bgp
as-number
—
Enter IPv4 MBGP address family
view
ipv4-family multicast
—
Advertise the
community
attribute to
an MBGP
peer/peer
group
peer
{
group-name |
ip-address
}
advertise-community
Advertise the
community
attribute to an
MBGP peer/peer
group
Advertise the
extended
community
attribute to
an MBGP
peer/peer
group
peer
{
group-name |
ip-address
}
advertise-ext-community
Required
Not configured by default.
Apply a route policy to routes
advertised to an MBGP peer/peer
group
peer
{
group-name
|
ip-address
}
route-policy
route-policy-name
export
Required
Not configured by default.
z
When configuring MBGP community, you need to reference a route policy to define the specific
community attributes, and apply the route policy for route advertisement.
z
For route policy configuration, refer to
Route Policy Configuration
in the
IP Routing Volume
.
Summary of Contents for S7906E - Switch
