3Com S7906E - Switch, Configuration Manual

Page: 318 / 2621

3-18
After you configure the updating of the ONUs corresponding to all the created ONU ports under an OLT
port, if the ONU port corresponding to an ONU that goes online is created before the update command
is used, the ONU will be updated directly (if it matches the update files); otherwise, the ONU will not be
updated.
Restarting an ONU
Follow these steps to restart an ONU:
To do... Use the command... Remarks
Enter system view
system-view
—
Enter ONU port view
interface onu
interface-number
—
Restart the ONU
reboot onu
Required
Displaying and Maintaining ONU Port Configuration
To do... Use the command... Remarks
Display the global information
about the ONU
display vendor-specific
information
Display the IP address
allocation information when the
ONU serves as a DHCP client
display dhcp-client
Display the information about
the protocols supported by the
ONU
display onu-protocol
[
stp
|
igmp-snooping
|
dhcp-snooping information
]
Display multicast control
information
display epon-multicast
information
Available in ONU port view
To display the information of an
ONU, make sure the ONU is
online.
Clear the statistics information
about the packets on an ONU
port
reset counters interface
interface-type interface-number
Available in user view
Configuration Examples for ONU Remote Management
Configuration Example for Binding an ONU Port to an ONU
Network requirements
Bind ONU 3/0/1:1 to ONU 1, whose MAC address is 000f-e200-0031, and ONU 3/0/1:2 to ONU 2,
whose MAC address is 000f-e200-3749. ONU 1 and ONU 2 have the same extended OAM version of 2.