3Com S7906E - Switch, Configuration Manual

Page: 1470 / 2621

1-36
[SwitchB-Vlan-interface10] quit
[SwitchB] interface vlan-interface 11
[SwitchB-Vlan-interface11] mpls
[SwitchB-Vlan-interface11] mpls ldp
[SwitchB-Vlan-interface11] quit
# Configure Switch C.
[SwitchC] mpls lsr-id 1.1.1.9
[SwitchC] mpls
[SwitchC-mpls] quit
[SwitchC] mpls ldp
[SwitchC-mpls-ldp] quit
[SwitchC] interface vlan-interface 11
[SwitchC-Vlan-interface11] mpls
[SwitchC-Vlan-interface11] mpls ldp
[SwitchC-Vlan-interface11] quit
After completing the above configurations, local sessions should have been established between
Switch A and Switch B and between Switch B and Switch C. You can execute the
display mpls ldp
session
command to check whether the local sessions have been established, or use the
display
mpls ldp peer
command to check the peers. The following takes Switch A as an example:
[SwitchA] display mpls ldp session
LDP Session(s) in Public Network
Total number of sessions: 1
----------------------------------------------------------------
Peer-ID Status LAM SsnRole FT MD5 KA-Sent/Rcv
----------------------------------------------------------------
2.2.2.9:0 Operational DU Passive Off Off 5/5
----------------------------------------------------------------
LAM : Label Advertisement Mode FT : Fault Tolerance
[SwitchA] display mpls ldp peer
LDP Peer Information in Public network
Total number of peers: 1
-----------------------------------------------------------------
Peer-ID Transport-Address Discovery-Source
----------------------------------------------------------------
2.2.2.9:0 2.2.2.9 Vlan-interface10
----------------------------------------------------------------
4) Configure the remote LDP session
# Configure Switch A.
[SwitchA] mpls ldp remote-peer peerc
[SwitchA-mpls-ldp-remote-peerc] remote-ip 3.3.3.9
[SwitchA-mpls-ldp-remote-peerc] quit
# Configure Switch C.
[SwitchC] mpls ldp remote-peer peera
[SwitchC-mpls-ldp-remote-peera] remote-ip 1.1.1.9
[SwitchC-mpls-ldp-remote-peera] quit