3Com S7906E - Switch, Configuration Manual

Page: 917 / 2621

1-19
Configuring an IPv6 BGP Route Reflector
Follow these steps to configure an IPv6 BGP route reflector:
To do… Use the command… Remarks
Enter system view
system-view
—
Enter BGP view bgp as-number
—
Enter IPv6 address family view ipv6-family
—
Configure the router as a route
reflector and specify an IPv6
peer/peer group as a client
peer { ipv6-group-name |
ipv6-address } reflect-client
Required
Not configured by default.
Enable route reflection
between clients
reflect between-clients
Optional
Enabled by default.
Configure the cluster ID of the
route reflector
reflector cluster-id cluster-id
Optional
By default, a route reflector
uses its router ID as the cluster
ID
z
In general, since the route reflector forwards routing information between clients, it is not required
to make clients of a route reflector fully meshed. If clients are fully meshed, it is recommended to
disable route reflection between clients to reduce routing costs.
z
If a cluster has multiple route reflectors, you need to specify the same cluster ID for these route
reflectors to avoid routing loops.
Displaying and Maintaining IPv6 BGP
Displaying BGP
To do… Use the command… Remarks
Display IPv6 BGP peer group
information
display bgp ipv6 group [ ipv6-group-name ]
Display IPv6 BGP advertised
routing information
display bgp ipv6 network
Display IPv6 BGP AS path
information
display bgp ipv6 paths [ as-regular-expression ]
Display IPv6 BGP peer/peer
group information
display bgp ipv6 peer [ group-name log-info |
ipv4-address verbose | ipv6-address { log-info |
verbose } | verbose ]
Display the prefix entries in the
ORF information of the
specified BGP peer
display bgp ipv6 peer { ip-address |
ipv6-address } received ipv6-prefix
Display IPv6 BGP routing table
information display bgp ipv6 routing-table [ ipv6-address
prefix-length ]
Available in
any view