3Com S7906E - Switch, Configuration Manual

Page: 845 / 2621

1-2
Each RIPng router maintains a routing database, including route entries of all reachable destinations. A
route entry contains the following information:
z
Destination address: IPv6 address of a host or a network.
z
Next hop address: IPv6 address of a neighbor along the path to the destination.
z
Egress interface: Outbound interface that forwards IPv6 packets.
z
Metric: Cost from the local router to the destination.
z
Route time: Time that elapsed since a route entry is last changed. Each time a route entry is
modified, the routing time is set to 0.
z
Route tag: Identifies the route, used in a routing policy to control routing information. For
information about routing policy, refer to Routing Policy Configuration in the IP Routing Volume .
RIPng Packet Format
Basic format
A RIPng packet consists of a header and multiple route table entries (RTEs). The maximum number of
RTEs in a packet depends on the IPv6 MTU of the sending interface.
Figure 1-1 shows the packet format of RIPng.
Figure 1-1 RIPng basic packet format
z
Command: Type of message. 0x01 indicates Request, 0x02 indicates Response.
z
Version: Version of RIPng. It can only be 0x01 currently.
z
RTE: Route table entry, 20 bytes for each entry.
RTE format
There are two types of RTEs in RIPng.
z
Next hop RTE: Defines the IPv6 address of a next hop
z
IPv6 prefix RTE: Describes the destination IPv6 address, route tag, prefix length and metric in the
RIPng routing table.
Figure 1-2 shows the format of the next hop RTE:
Figure 1-2 Next hop RTE format
IPv6 next hop address is the IPv6 address of the next hop.
Figure 1-3 shows the format of the IPv6 prefix RTE.