3Com S7906E - Switch, Configuration Manual

Page: 2165 / 2621

1-14
To do… Use the command… Remarks
Assign the interface to the
protected VLANs of the current
RRPP domain
port trunk permit vlan
{ vlan-id-list | all }
Optional
By default, an interface only
allows packets of its default
VLAN to pass through.
Disable STP undo stp enable
Required
Enabled by default
z
For detailed information about the port link-type trunk command and port trunk permit vlan
{ vlan-id-list | all } command, refer to VLAN Commands in the Access Volume .
z
For detailed information about the undo stp enable command, refer to MSTP Commands in the
Access Volume .
z
Do not enable OAM remote loopback function on an RRPP port. Otherwise, this may cause
temporary broadcast storm.
z
You are recommended to use the link-delay command to enable link status rapid report function
on an RRPP port by setting the link-delay of the port to 0 to accelerate topology convergence. For
detailed information about the link-delay command, refer to Ethernet Port Commands in the
Access Volume .
Configuring RRPP Nodes
z
The maximum number of rings that can be configured on a device in all RRPP domains is 16.
z
If a device carries multiple RRPP rings in an RRPP domain, only one ring can be configured as the
primary ring on the device and the role of the device on a subring can only be an edge node or an
assistant-edge node.
Specifying a master node
Perform this configuration on a device to be configured as a master node.
Follow these steps to specify a master node:
To do… Use the command… Remarks
Enter system view system-view —
Enter RRPP domain view rrpp domain domain-id —