3Com S7906E - Switch, Configuration Manual

Page: 1220 / 2621

1-33
IGMP Snooping Proxying Configuration Example
Network requirements
As shown in Figure 1-7 ,
z
Router A connects to a multicast source through port GigabitEthernet 2/0/2, and to Switch A
through port GigabitEthernet 2/0/1.
z
Router A runs IGMPv2 and Switch A runs IGMPv2 Snooping. Router A serves as an IGMP querier.
Configure IGMP snooping proxying on Switch A, enabling the switch to forward IGMP reports and leave
messages on behalf of attached hosts and to respond to IGMP queries from Router A and forward the
queries to the hosts on behalf of Router A.
Figure 1-7 Network diagram for IGMP snooping proxying configuration
Source
Router A
IGMP querier
Switch A
Proxy & Querier
Receiver
Host B
Host A
Host C
1.1.1.1/24
GE2/0/4
GE2/0/2
GE2/0/3 GE2/0/1
GE2/0/1
10.1.1.1/24
GE2/0/2
1.1.1.2/24
Receiver
Configuration procedure
1) Configure IP addresses for interfaces
Configure an IP address and subnet mask for each interface as per Figure 1-7 . The configuration steps
are omitted here.
2) Configure Router A
# Enable IP multicast routing, enable PIM-DM on each interface, and enable IGMP on GigabitEthernet
2/0/1.
<RouterA> system-view
[RouterA] multicast routing-enable
[RouterA] interface gigabitethernet 2/0/1
[RouterA-Gigabitethernet2/0/1] igmp enable
[RouterA-Gigabitethernet2/0/1] pim dm
[RouterA-Gigabitethernet2/0/1] quit
[RouterA] interface gigabitethernet 2/0/2
[RouterA-Gigabitethernet2/0/2] pim dm
[RouterA-Gigabitethernet2/0/2] quit
3) Configure Switch A
# Enable IGMP snooping globally.