3Com S7906E - Switch, Configuration Manual

Page: 1617 / 2621

1-102
Figure 1-27 Configure BGP AS number substitution
Loop0
Loop0 Loop0
PE 1
P PE 2
CE 1
CE 2
VPN 1 VPN 1
Vlan-int12
MPLS backbone
Vlan-int12 Vlan-int11
Vlan-int11
Vlan-int12
Vlan-int11
Vlan-int12
Vlan-int12
Vlan-int11
Vlan-int11
Device Interface IP address Device Interface IP address
CE 1 Vlan-int11 10.1.1.1/24 P Loop0 2.2.2.9/32
Vlan-int12 100.1.1.1/24 Vlan-int11 30.1.1.1/24
PE 1 Loop0 1.1.1.9/32 Vlan-int12 20.1.1.2/24
Vlan-int11 10.1.1.2/24 PE 2 Loop0 3.3.3.9/32
Vlan-int12 20.1.1.1/24 Vlan-int11 30.1.1.2/24
CE 2 Vlan-int12 10.2.1.1/24 Vlan-int12 10.2.1.2/24
Vlan-int11 200.1.1.1/24
Configuration procedure
1) Configuring basic MPLS L3VPN
z
Configure OSPF on the MPLS backbone to allow the PEs and P device to learn the routes of the
loopback interfaces from each other.
z
Configure MPLS basic capability and MPLS LDP on the MPLS backbone to establish LDP LSPs.
z
Establish MP-IBGP peer relationship between the PEs to advertise VPN IPv4 routes.
z
Configure the VPN instance of VPN 1 on PE 2 to allow CE 2 to access the network.
z
Configure the VPN instance of VPN 1 on PE 1 to allow CE 1 to access the network.
z
Configure BGP between PE 1 and CE 1, and between PE 2 and CE 2 to inject routes of CEs into
PEs.
After completing the above configurations, if you issue the display ip routing-table command on CE 2,
you should see that CE 2 has learned the route to network segment 10.1.1.0/24, where the interface
used by CE 1 to access PE 1 resides; but has not learned the route to the VPN (100.1.1.0/24) behind
CE 1. You should see the similar situation on CE 1.
<CE2> display ip routing-table
Routing Tables: Public
Destinations : 8 Routes : 8
Destination/Mask Proto Pre Cost NextHop Interface
10.1.1.0/24 BGP 255 0 10.2.1.2 Vlan12
10.1.1.1/32 BGP 255 0 10.2.1.2 Vlan12
10.2.1.0/24 Direct 0 0 10.2.1.1 Vlan12
10.2.1.1/32 Direct 0 0 127.0.0.1 InLoop0
10.2.1.2/32 Direct 0 0 10.2.1.2 Vlan12