3Com S7906E - Switch, Configuration Manual

Page: 614 / 2621

1-16
To do… Use the command… Remarks
Enter system view
system-view
––
Enter RIP view
rip [ process-id ]
[ vpn-instance
vpn-instance-name ]
––
Specify a RIP neighbor peer ip-address Required
Disable source address check
on incoming RIP updates undo
validate-source-address
Required
Not disabled by default
z
You need not use the peer ip-address command when the neighbor is directly connected;
otherwise the neighbor may receive both the unicast and multicast (or broadcast) of the same
routing information.
z
If a specified neighbor is not directly connected, you need to disable source address check on
incoming updates.
Configuring RIP-to-MIB Binding
This task allows you to enable a specific RIP process to receive SNMP requests.
Follow these steps to bind RIP to MIB:
To do… Use the command… Remarks
Enter system view system-view ––
Bind RIP to MIB rip mib-binding process-id
Optional
By default, MIB is bound to RIP
process 1.
Configuring the RIP Packet Sending Rate
RIP periodically sends routing information in RIP packets to RIP neighbors.
Sending large numbers of RIP packets at the same time may affect device performance and consume
large network bandwidth. To solve this problem, you can specify the maximum number of RIP packets
that can be sent at the specified interval.
Follow these steps to configure the RIP packet sending rate:
To do… Use the command… Remarks
Enter system view system-view ––
Enable a RIP process and
enter RIP view
rip [ process-id ]
[ vpn-instance
vpn-instance-name ]
––