3Com S7906E - Switch, Configuration Manual

Page: 2163 / 2621

1-12
Follow these steps to create an RRPP domain:
To do… Use the command… Remarks
Enter system view system-view —
Create an RRPP domain and
enter RRPP domain view
rrpp domain domain-id Required
Configuring Control VLANs
Before configuring RRPP rings in an RRPP domain, configure the same control VLANs for all nodes in
the RRPP domain first.
Perform this configuration on all nodes in the RRPP domain to be configured.
Follow these steps to configure control VLANs:
To do… Use the command… Remarks
Enter system view system-view —
Enter RRPP domain view rrpp domain domain-id —
Specify the primary control
VLAN for the RRPP domain
control-vlan vlan-id Required
z
To ensure proper forwarding of RRPPDUs, do not enable QinQ or VLAN mapping on the control
VLANs.
z
To ensure that RRPPDUs can be sent and received correctly, do not configure the default VLAN of
a port accessing an RRPP ring as the primary control VLAN or the secondary control VLAN.
z
To transparently transmit RRPPDUs on a device not configured with RRPP, you must ensure only
the two ports connecting the device to the RRPP ring permit the packets of the control VLANs.
Otherwise, the packets from other VLANs may go into the control VLANs in transparent
transmission mode and strike the RRPP ring.
Configuring Protected VLANs
Before configuring RRPP rings in an RRPP domain, configure the same protected VLANs for all nodes
in the RRPP domain first. All VLANs that the RRPP ports are assigned to should be protected by the
RRPP domains.
Perform this configuration on all nodes in the RRPP domain to be configured.