3Com S7906E - Switch, Configuration Manual

Page: 2072 / 2621

1-3
To do… Use the command… Remarks
Enter system view
system-view
—
Manually restart the SMB slave restart Required
After the SMB has restarted, the AMB will perform initial synchronization on the SMB. During this
process, the system does not respond to your input. After the initial synchronization is completed, you
can execute all the configuration commands on the AMB and the AMB and SMB will keep a real-time
synchronization process, meaning your configuration on the AMB will be copied to the SMB to ensure
the consistency of the current configuration of the AMB and SMB.
Manually Configuring Switchover Between the AMB and SMB
To do… Use the command… Remarks
Enter system view system-view —
Enable the manual switchover
between the AMB and SMB slave switchover { disable |
enable }
Optional
Enabled by default
Manually configure switchover
between the AMB and SMB
slave switchover Required
The original AMB will be restarted if an AMB and SMB switchover is performed. Therefore, ensure the
consistency of the software version of the AMB and SMB before performing an AMB and SMB
switchover. By default, if the versions of the AMB and SMB are not consistent, the original AMB cannot
be restarted; to perform an AMB and SMB switchover in case that their versions are not consistent,
configure to ignore version check of the SMB.
Displaying and Maintaining Dual-SRPU System
To do… Use the command… Remarks
Display the switchover state
(independent mode) display switchover state
[ slot slot-number ]
Display the switchover state
(IRF mode)
display switchover state
[ chassis chassis-number slot
slot-number ]
Available in any view