3Com S7906E - Switch, Configuration Manual

Page: 902 / 2621

1-4
To do… Use the command… Remarks
Enter system view
system-view
—
Enter BGP view bgp as-number
—
Enter IPv6 address family view ipv6-family
—
Configure a preferred value for
routes received from an IPv6
peer/peer group peer { ipv6-group-name |
ipv6-address } preferred-value
value
Optional
By default, the preferred value
is 0.
If you both reference a routing policy and use the command peer { ipv6-group-name | ipv6-address }
preferred-value value to set a preferred value for routes from a peer/peer group, the routing policy sets
a non-zero preferred value for routes matching it. Other routes not matching the routing policy uses the
value set with the command. If the preferred value in the routing policy is zero, the routes matching it will
also use the value set with the command. For information about using a routing policy to set a preferred
value, refer to the command peer { group-name | ipv4-address | ipv6-address } route-policy
route-policy-name { import | export } in this document, and the command apply preferred-value
preferred-value in Routing Policy Commands of the IP Routing Volume .
Specifying the Source Interface for Establishing TCP Connections
Follow these steps to specify the source interface for establishing TCP connections to a BGP peer or
peer group:
To do… Use the command… Remarks
Enter system view system-view
—
Enter BGP view bgp as-number
—
Enter IPv6 address family view ipv6-family
—
Specify the source interface for
establishing TCP connections
to an IPv6 BGP peer or peer
group peer { ipv6-group-name |
ipv6-address }
connect-interface
interface-type interface-number
Required
By default, IPv6 BGP uses the
outbound interface of the best
route to the IPv6 BGP peer or
peer group as the source
interface for establishing a TCP
connection.