3Com S7906E - Switch, Configuration Manual

Page: 1121 / 2621

1-2
Protocols and Standards
z
RFC2858: Multiprotocol Extensions for BGP-4
z
RFC3392: Capabilities Advertisement with BGP-4
z
draft-ietf-idmr-bgp-mcast-attr-00: BGP Attributes for Multicast Tree Construction
z
RFC4271: A Border Gateway Protocol 4 (BGP-4)
z
RFC5291: Outbound Route Filtering Capability for BGP-4
z
RFC5292: Address-Prefix-Based Outbound Route Filter for BGP-4
MBGP Configuration Task List
Complete the following tasks to configure MBGP:
Task Remarks
Configuring MBGP Basic Functions Required
Configuring MBGP Route Redistribution Required
Configure Default Route Redistribution into MBGP Optional
Configuring MBGP Route Summarization Optional
Advertising a Default Route to an IPv4 MBGP Peer or Peer
Group
Optional
Configuring Outbound MBGP Route Filtering Optional
Configuring Inbound MBGP Route Filtering Optional
Controlling Route
Advertisement and
Reception
Configuring MBGP Route Dampening
Configuring MBGP Route Preferences
Configuring the Default Local Preference
Configuring the MED Attribute
Configuring the Next Hop Attribute
Configuring MBGP
Route Attributes
Configuring the AS-PATH Attribute
Optional
Configuring MBGP Soft Reset Optional
Enabling the MBGP ORF Capability
Tuning and
Optimizing MBGP
Networks
Configuring the Maximum Number of MBGP Routes for
Load Balancing
Optional
Configuring IPv4 MBGP Peer Groups Optional
Configuring MBGP Community Optional
Configuring a
Large Scale
MBGP Network
Configuring an MBGP Route Reflector Optional
Configuring MBGP Basic Functions
Prerequisites
Before configuring MBGP, make sure neighboring nodes can access each other at the network layer.