YASKAWA HV600, Руководство пользователя

Страница: 548 / 610

3.6 Keypad Operation
548 YASKAWA TOEPYAIHV6002A HV600 Drive Programming
8.
When the keypad shows the Auto-Tuning start screen, push .
Auto-Tuning starts.
When doing Rotational Auto-Tuning, the motor will stay stopped for approximately one minute with power
energized and then the motor will start to rotate.
9.
When the keypad shows this screen after Auto-Tuning is complete for 1 or 2 minutes, push or .
The keypad will show a list of the changed parameters as the result of Auto-Tuning.
10.
Push or in the parameter change confirmation screen to check the changed parameters, then select
[Auto-Tuning Successful] at the bottom of the screen and push .
To change a parameter again, push or to select the parameter to change, then push to show the
parameter setting screen.
Auto-Tuning is complete.
Note:
If the drive detects an error or you push before Auto-Tuning is complete, Auto-Tuning will stop and the keypad will show an error
code. Endx identifies that Auto-Tuning was successful with calculation errors. Find and repair the cause of the error and do Auto-Tuning
again, or set the motor parameters manually. You can use the drive in the application if you cannot find the cause of the Endx error. Er-xx
identifies that Auto-Tuning was not successful. Find and repair the cause of the error and do Auto-Tuning again.
◆
Set the Keypad Language Display
The procedure in this section shows how to set the language shown on the keypad.
1.
Push (Home) to show the HOME screen.
Note:
• The keypad will show [Home] in the top right corner when the HOME screen is active.
• If [Home] is not shown on , push (Back), to show [Home] on .