Ross SYNERGY 4000DR-003, Руководство по эксплуатации, Страница: 195 / 332

Synergy Series Operation Guide (v18) Keying • 7–21
Self Key Setup Menu — Transparency On
• Use the
Transparency
knob to adjust transparency from opaque (0%) to fully
transparent (100%).
7. If desired, you can toggle the
Key Over
button between
On
and
Off
to change the
priority of the two keyers:
•
On
— Select
On
to change the priority to Key 1 , setting it over (visually on top of)
Key 2 . The
KEY OVER
button in the MLE Key 1 Group will now be lit.
• Off — Select Off to keep the priority as Key 2 over Key 1 . This is the default
setting.
8. Select additional key modifiers as desired, using the controls in Key Modifier Sections
1 and 2 . Modifiers include:
•
MATTE FILL
•
KEY INV
• MASK
•
FLY KEY
• Border Effects
Refer to the section “ Using Key Modifiers ” on page 7–49 for details.
9. If desired, preview the key by pressing KEY PV .
10. Select the desired transition:
• Press CUT (in the MLE Key Group ) to cut the key on (or off) air. Refer to the
section “ Key Cut Notes ” on page 7–47 for additional rules.
• Select an auto transition rate, then press
AUTO TRANS
(in the MLE Key Group )
to dissolve the key on (or off) air. Refer to the section “ Using Auto Transitions ” on
page 7–45 for instructions on selecting key dissolve rates. For additional rules, refer
to the section “
Key Auto Transition Notes ” on page 7–47.
• Use the proper
KEY 1
or
KEY 2
“next transition” button (in the MLE Transition
Group ) to bring the key on (or off) air. Refer to the section “ Working with Next
Transitions ” on page 5–9 for complete instructions on the three “next transition”
buttons.
This completes the procedure to perform a self key on an MLE Keyer.