Ross SYNERGY 4000DR-003, Руководство по эксплуатации, Страница: 140 / 332

5–8 • Background Transitions Synergy Series Operation Guide (v18)
5. Press
CUT
.
The inputs selected on the PGM and PST buses instantly exchange and the buses
flip-flop. The following figure illustrates the MLE and monitor setup after the cut.
6. Press CUT again to repeat the process and restore the original background.
This completes the procedure to perform a cut.
Using Dissolves
Dissolves can be performed in any MLE. In a “background dissolve” transition, the PGM bus video
and PST bus video signals are gradually mixed together, until the PST bus video completely replaces
the PGM bus video.
Use the following procedure to perform a dissolve:
1. Check that your program/preview monitoring is set as needed for the selected MLE.
2. Select an input on the MLE’s PGM bus.
3. Select a different input on the MLE’s PST bus.
4. In the Next Transition Section , select BKGD as the next transition. The following
figure illustrates a sample MLE setup and the associated monitor outputs — before the
dissolve.
5. In the Transition Parameter Section , press DISS .
6. To perform a manual transition, move the Fader from limit to limit. To perform an auto
transition, press the AUTO TRANS button. During the transition, the PST bus video
signal gradually mixes into the PGM signal, as shown below.
BLACK
PGM
PST
CAM
1
CAM
2
CAM
3
CAM
4
BLACK
CAM
1
CAM
2
CAM
3
CAM
4
Preview Monitor
(CAM 1)
Program Monitor
(CAM 3)
BLACK
PGM
PST
CAM
1
CAM
2
CAM
3
CAM
4
BLACK
CAM
1
CAM
2
CAM
3
CAM
4
Preview Monitor
(CAM 3)
Program Monitor
(CAM 1)