Ross SYNERGY 4000DR-003, Руководство по эксплуатации, Страница: 114 / 332

4–36 • Switcher Basics Synergy Series Operation Guide (v18)
1. Cut to Black
Press
CUT
to instantly cut the switcher output to black. When the switcher is in black,
press
CUT
again to cut the switcher back to the previous full on-air program output.
2. Fade to Black
Press
FADE
to fade (auto transition) the switcher output to black, using the assigned
Fade to Black rate. When the switcher is in black, press
FADE
again to fade the switcher
up from black — back to the previous full on-air program output.
3. Display
The 3-digit display shows the current Fade to Black transition rate, as entered in the
Global Memory System Group .
Please note the following important points regarding the Fade to Black function:
• Once the switcher is in black, it stays in black until
CUT
or
FADE
is pressed again.
• When the switcher is in black, the
FADE
button stays lit to indicate that the switcher is
in full Fade to Black mode. In addition, any on-air tally LEDs and any active keyer
LEDs (that were previously lit in the on-air mode) will flash as an extra attention-getting
indication of the switcher’s mode.
• If you are performing a long
FADE
(either to or from black) and you wish to change
your mind, there are several options:
~ Press
FADE
again (during the fade transition) to reverse direction and return to the
starting point (full program or full black).
~ Press
CUT
to complete the transition, in the current direction.
Changing Fade to Black Rates
Use the following procedure to change the Fade to Black auto transition rates:
1. Note the current Fade to Black auto transition rate, as shown in the Fade to Black
group’s Display .
2. Press the FADE RATE button in the Global Memory Group . This button is identical
for all three Synergy switchers.
3. Using the keypad in the Global Memory Group , enter the desired Fade to Black rate in
frames — from 1 to 999 . The rate is displayed on the display’s top line, and the ENTER
button lights.
Fade to Black Rate Display
To accept the new rate, press
ENTER
. The display updates as shown below, the
ENTER
light turns off, and the new rate is available for use. The display in the Fade to Black
Group also updates.
Updated Fade to Black Rate
This completes the procedure to change the Fade to Black auto transition rates.
New FTB Rate:015
M:015 D:008 F:20
REG:00 Memory0
M:015 D:008 F:20