Ross SYNERGY 4000DR-003, Руководство по эксплуатации, Страница: 135 / 332

Synergy Series Operation Guide (v18) Background Transitions • 5–3
Note that the sections are numbered in an identical manner for both transition groups.
1. Fader Section
The Fader handle is used to perform manual transitions. The “type” of transition is
based on the transition button that is selected in the Transition Parameter Section —
Dissolve, Wipe, or DVE Send. The Fader performs one complete transition when it is
moved from one limit to the other. Due to the switcher’s flip-flop architecture, it does
not matter at which limit the transition begins. The PGM bus
always remains the
program output.
Two LED indicators (
Up
arrow,
Down
arrow) located to the left of the Fader indicate
the direction of Fader travel during a transition. For full or partial transitions (when the
Fader is paused part-way through), the arrow that is lit indicates the direction that the
Fader must be moved in order to complete the transition.
Above the Fader (in the Program/Preset Transition group only), the display indicates
the group’s current auto-transition rate (in frames). For all switchers, this rate is
programmed in the
Global Memory System group.
For convenience, the rate is shown in two places — the display (above the Fader ), and
the bottom left hand field in the Global Memory System group’s display (
M:###
).
Global Memory System Display
2. Next Transition Section
For all switchers, the Next Transition Section includes three buttons that allow you to
select the combination of actions that will be included in the next transition .
All three buttons are latching toggles — they can be enabled in any combination. When
pressed, the output video is not affected — only the actions in the
next transition are
affected.
• Enable
BKGD
to include a transition between the PGM and PST buses (in the
Program/Preset Transition group), or between the BKGD and PST buses (in the
MLE Transition group). When a manual or auto-transition is performed, the video
selected on PST transitions to PGM .
• Enable DSK 1 (in the Program/Preset Transition group) or KEY 1 (in the MLE
Transition group) to perform a transition of the MLE’s first keyer.
~ If the keyer is currently off, the transition brings on the key, and the
ACTIVE
LED directly below the button lights red or green.
~ If the keyer is currently on, the transition removes the key, and the
ACTIVE
LED below turns off.
Refer to the section “ Working with Next Transitions ” on page 5–9 for more
information on the
ACTIVE
LEDs.
Note When a DSK transition is performed within a DSK Keyer, the display
above the Fader (in the
Program/Preset Transition group only)
briefly updates with the rate of the selected DSK’s transition. Once the
transition has completed, the display returns to the MLE transition rate.
Refer to the section “
Performing a Downstream Key ” on page 7–39
for details.
FRAMES
REG:00 Memory0
M:015 D:008 F:20
BKGD
DSK1 KEY1