Ross SYNERGY 4000DR-003, Руководство по эксплуатации, Страница: 158 / 332

6–8 • Pattern Control Synergy Series Operation Guide (v18)
Using Wipes
Wipes can be performed in any MLE. In a “background wipe” transition, the PGM (or BKGD ) bus
video is gradually replaced with the PST bus video according to a wipe pattern pre-selected from the
Pattern Selection Section in the Pattern Control group.
Use the following procedure to perform a wipe:
1. Check that your program/preview monitoring is set as needed for the selected MLE.
2. Select an input on the MLE’s PGM/BKGD bus.
3. Select a different input on the MLE’s PST bus.
4. In the Next Transition Section , select BKGD as the next transition. The following
figure illustrates a sample MLE setup and the associated monitor outputs — before the
wipe.
5. In the Transition Parameter Section , press WIPE . This action automatically assigns
the Pattern Control group to the MLE.
6. In the Pattern Selection Section , press the button for the desired wipe pattern.
7. In the Pattern Direction Section , choose the direction for the wipe. Select between
NORM , REV , or FLIP FLOP .
8. Turn the BORDER knob fully clockwise, then fully counterclockwise. For this first
exercise, this ensures that there is no border .
9. To perform a manual transition, move the Fader from limit to limit. To perform an auto
transition, press the AUTO TRANS button. During the transition, the PST bus video
signal gradually replaces the PGM/BKGD signal using the selected wipe, as shown
below.
At the end of the transition, the PST video completely replaces the PGM/BKGD video,
and the buses flip-flop.
BLACK
PGM
PST
CAM
1
CAM
2
CAM
3
CAM
4
BLACK
CAM
1
CAM
2
CAM
3
CAM
4
Preview Monitor
(CAM 3)
Program Monitor
(CAM 1)
BLACK
PGM
PST
CAM
1
CAM
2
CAM
3
CAM
4
BLACK
CAM
1
CAM
2
CAM
3
CAM
4
Preview Monitor
(CAM 3)
Program Monitor
(CAM 1 and CAM 3)