Ross SYNERGY 4000DR-003, Руководство по эксплуатации, Страница: 283 / 332

Synergy Series Operation Guide (v18) Custom Controls • 9–3
Synergy 4
The following figure illustrates the Custom Control Group for the Synergy 4, 2003 edition panel. A
total of 35 registers are provided, up to eight of which can be assigned as banks to increase the total
number of available registers.
Custom Control Group — Synergy 4 Panel, 2003 Edition
Buttons are numbered to simplify the programming procedure. The numbering is
1
to
35
in ascending
order, from left to right.
Custom Control Functionality
Custom control functionality falls into several different categories:
Custom Control Banks
Up to eight banks can be enabled, and you can select any of the available custom control buttons on
which to place the bank buttons themselves. Each bank stores a separate set of custom controls.
Control Panel Functions
A custom control button can be programmed to play back a series of control panel button presses —
such as recalling memory registers, initiating auto transitions, taking a selected source, bringing up a
CG, and calling other custom control macros. In addition, the following functions are available:
• VTR Functions — A custom control button can be programmed to perform a specific
transport command such as play, cue and rewind. Commands apply to serial controlled
devices such as VTRs and Video Servers. The
VTR Remote Control or Video Sever
Control option must be installed, respectively. Any combination of options can be
installed.
• DVE Functions — Using the primary DVE, a custom control button can be
programmed to perform a specific DVE command such as play effect, frame advance,
and stop. The
DVE Send and Remote Control Option must be installed.
• Time Clock Functions — A custom control button can be programmed to start, stop, or
reset the preview overlay clock. The Preview Overlay Option must be installed.
Note If you have a Synergy 4 panel manufactured prior to the 2003 edition
panels, a total of 32 registers are available, eight of which can be
assigned as banks.
Operating
Tip
You can record a custom control that will select a bank as the last event
in the macro. Refer to Chapter 8, “
Custom Control Basics ”, in the
Synergy Series Installation Guide for details.
Operating
Tip
You can record a custom control that will execute another custom
control as the last event in the macro. Refer to Chapter 8, “
Custom
Control Basics ”, in the Synergy Series Installation Guide .
INTRO
1
INTRO
2
NEWS SPORT
VTR
REV VTR
STOP
VTR
PLAY
VTR
FF
DVE
FWD
CUSTOM
28
CUSTOM
29
CUSTOM
30
CUSTOM
31
CUSTOM
32
CUSTOM
33
CUSTOM
34
CUSTOM
35