Ross SYNERGY 4000DR-003, Руководство по эксплуатации, Страница: 221 / 332

Synergy Series Operation Guide (v18) Keying • 7–47
4. Press ENTER to accept the new rate.
The display updates as shown below, the ENTER light turns off, and the new rate is
available for use.
This completes the procedure to change the MLE Rate.
Key Auto Transition Notes
Please note the following important points regarding key auto transitions:
• An auto transition, once in progress, cannot be paused.
• To “escape” from an auto transition in progress, you can either press
CUT
during the
transition, or manually pull the Fader in the proper direction. The “cut” action instantly
completes the transition.
• In a single MLE, you cannot initiate an auto transition if the Fader is off its upper or
lower limit. If this effect is required, use a re-entry setup on the panel. Refer to the
section “
Key Cut Notes ” on page 7–47 for additional details.
• In a single MLE, you cannot initiate a keyer auto transition if an auto transition in the
MLE Transition Group is already in progress. If this effect is required, use a re-entry
setup on the panel.
• If the
TRANS LIMIT
function is enabled and the transition is at the selected limit, you
cannot initiate a keyer auto transition. If this effect is required, use a re-entry setup on
the panel.
• The keyer’s
CUT
and
AUTO TRANS
buttons are linked to those in the MLE
Transition Group . When you press
AUTO TRANS
in a keyer, the
DISS
,
AUTO
TRANS
and appropriate “key” next transition button lights in the MLE Transition
Group — to indicate a key transition in progress. When the transition is finished, the
buttons return to their previous states.
• Remember that you can transition the key with two different rates, depending on where
you press the
AUTO TRANS
button — either in the Keyer or in the MLE Transition
Group .
• You cannot wipe a key using the buttons in the Key 1 or Key 2 group. This function
must be performed in the MLE Transition Group .
Key Cut Notes
Key “cut” transitions (using the CUT buttons in the MLE Keyer groups and DSK groups) can be
performed when the Fader is off its upper or lower limit. However, auto transitions (using the keyer
AUTO TRANS buttons) cannot be performed at all when the fader is off a limit, or when an auto
transition is in progress.
Operating
Tip
If you do not want to change the auto transition rate at this time, press
any of the
RATE or STORE buttons to cancel entering a new rate.
If you want to enter a different rate prior to pressing
ENTER
, simply
continue to type until the desired value appears.
REG:00 Memory0
MLE:015 KEY:008