Rohde & Schwarz SMM100A, Руководство пользователя

Страница: 622 / 1088

Network operation and remote control
R&S
®
SMM100A
622 User Manual 1179.1341.02 ─ 05
Example:
The default hostname of an R&S SMM100A with a serial number 102030 is
SMM100A-102030
.
To query and change a computer name
1. Select "System Config > Remote Access > Network".
The computer name is displayed under "Hostname".
2. Select "System Config > Setup > Security > Protection".
3. Enable the "Protection Level 1".
The default password is 123456 .
The parameter "Hostname" in the "Network" tab is now enabled for configuration.
4. Change the "Hostname".
12.8 Controlling the R&S SMM100A remotely
This section shows you how to set up remote control connections over the available
interfaces.
The following general prerequisites must be fulfilled:
●
The instrument and the controller have to be connected with the suitable cable and
switched on.
See
Chapter 12.7, "Connecting the instrument to the network (LAN)" , on page 619.
●
To operate the instrument via remote control, it must be addressed using the
defined interface address.
See:
–
Chapter 12.2.1, "LAN interface" , on page 582
– Chapter 12.2.2, "USB interface" , on page 584
– Chapter 12.2.3, "GPIB interface (IEC/IEEE bus interface)" , on page 585
●
A remote control program must open a connection to the instrument, before it can
send commands to and receive device responses from the instrument.
If security is a concern, see:
●
Document Instrument Security Procedures.
●
Chapter 11.5.5, "How to prevent unauthorized access" , on page 574.
Controlling the R&S SMM100A remotely