Rohde & Schwarz SMM100A, Руководство пользователя

Страница: 458 / 1088

Multi-instrument setups
R&S
®
SMM100A
458 User Manual 1179.1341.02 ─ 05
External Instrument ..................................................................................................... 460
I/Q Connection ............................................................................................................ 460
Remote Connection Status ......................................................................................... 461
Instrument Name .........................................................................................................461
RF Couple ................................................................................................................... 461
(Delta) RF Frequency/ RF Level ................................................................................. 462
RF State ...................................................................................................................... 462
Display
Filters the displayed connectors upon one of the following criteria:
"All Connectors"
No filter is applied.
"Mapped Connectors"
Displayed are only the connectors to which a stream is mapped.
Note: To prevent faults, use this filter before you further configure the
external instruments.
"Input Connectors/Output Connectors"
Filters the display according to connector direction.
Remote command:
:SCONfiguration:EXTernal:DISPlay
on page 720
Auto Connect
With enabled auto connect function, the instrument automatically detects connected
external instruments and establishes the required connection.
If the "Auto Connect > Off", however, after a R&S SMM100A startup you have to revise
the test setup and perform the following:
●
Check whether the necessary connections between the R&S SMM100A and the
external instruments are still existing.
●
Prove that the remote control of the particular instruments is required.
●
Trigger the Connect All Remote function.
Remote command:
:SCONfiguration:EXTernal:ACONnect
on page 720
Connect/Disconnect All Remote
Triggers the instrument to:
●
Establish the remote connections to all configured External Instruments .
●
To terminate all existing remote connections.
The external instruments are not removed from the list of external instruments.
Only the remote connection status changes.
Remote connection status can be toggled with the parameter Remote Connection Sta-
tus .
Note:
External instruments connected to the R&S SMM100A are preset (
:DEVice:PRESet
)
whenever:
●
The connection to the external instrument is established or terminated ("Connect/
Disconnect All Remote" or "Rem. Conn > On/Off")
●
The R&S SMM100A is preset ([Preset]).
System configuration settings