Oce VarioLink 6022, Руководство пользователя

Страница: 443 / 540

VarioLink 6022/7522 11-45
Utility mode 11
– Each time [+] or [-] is touched, the value is increased
or decreased by one increment.
– If the punch positions are too far blow the center of
the paper, touch [-] under "Adjust Value" to increase
the adjustment (between -0.1 mm and -5.0 mm).
8
Touch [OK].
– To cancel the setting and select the default, press the [Reset] key.
The vertical position of the punched holes is adjusted.
If no adjustment of the vertical position of the punched holes was necessary in step 7, this completes
the procedure.
9
Use a Punch setting to print another sample copy.
10
Check the print result.
– Check that the vertical position of the punched holes was adjusted.
– If more adjustment is necessary, repeat steps 6 through 9.
2
Note
Set the value by mm. Refer to the conversion rate below.
1 inch = 25.4 mm
11.6.5 Punch Horizontal Position Adjustment
The horizontal position of punched holes when printing with a Punch setting can be adjusted for each paper
size.
2
Note
[Punch Horizontal Position Adjustment] appears only if optional punch kit is installed on the finisher.
For details on the Punch settings, refer to
"Punching holes in copies (Punch settings)" on page 2-62
.
0 Before making any adjustments, use a Punch setting to print a sample copy. Perform the adjustment
while checking the sample that was created.
1
Display the Administrator Settings screen.
– For details on displaying the Administrator Settings screen, refer to "Displaying the Administrator
Settings screen" on page 11-36
.
2
Touch [1 System Settings].