Lucent Technologies Lineage 2000 J85503B-2, Руководство по эксплуатации продукта

Страница: 42 / 137

Lucent Technologies Lineage
®
2000 200A Ferroresonant Rectifier J85503B-2
3 - 8 Engineering and Ordering Issue 8 January 1999
Junction Plates 10. Order installation mounting plates (junction plates) for
side-to-side or front-to-back support at the top of adjacent
rectifiers from Table 3-D.
11. If local codes permit, you may connect an overhead
raceway to the rectifier with flex steel conduit. Flex steel
conduit kit (846860682) comes complete with 17 inches of
1-1/4 inch diameter flex steel conduit, two KS20785 L-39
connectors, and two KS20785 L-114 insulating bushings.
12. Use the cable ties provided with the plant to secure the
plant control cable to the top frame vertical post. The
control cable should pass through the spiral wrap to the
door where it is mounted with push-in tie wraps. You must
secure a tie wrap to the control cable just above the top lid
grommet so that the control cable cannot enter the rectifier
cabinet. Do not, under any circumstance, roll the control
cable up inside the rectifier. Roll up any extra length of
control cable and tie it up at the controller.
13. The J85503B-2 -48 volt rectifier is capable of forced load
share with other J85503B-2 rectifiers.
Spare Parts
The circuit modules described in Section 2 can be ordered as
spare parts kits (K1, K2, or K3). Each kit has the same packs
except for CM7, which is dependent on the J-List. Table 3-E
shows the contents of the kits along with the part numbers to
order modules individually.
Table 3-C: Shims Ordering Information
Thickness Comcode
0.063 inch 842439861
0.125 inch 842439879
0.250 inch 842439887
Table 3-D: Junction Plates Ordering Information
Type Comcode
Side-to-side 848204640
Front-to-back (2 or 4
rectifiers)
848204657
Bolt to secure plates 804220838