Section 1: Introduction
2606B System SourceMeter® Instrument Reference Manual
1-4
2606B-901-01 Rev. B / May 2018
What you should have received
In addition to the 2606B, you should have received the items listed in the following table.
Part number
Description
Quantity
CA-180-16
16 in. LAN crossover cable, 16 in.
2
174710700
Shielded crossover cable with RJ-45 connector, 5 ft.
1
Depends on country
Power line cord
1
CA-568
Green and yellow ground cable, 120 in.
1
407612600
1U rack rail mount (part of the Model 4299-13 Rack Mount Kit)
2
10-32X3/8PHTRSH
10-32X3/8 Phillips truss head screw (part of the Model 4299-13 Rack
Mount Kit)
4
10-32X5/8PHTRSH
10-32X5/8 Phillips truss head screw (part of the Model 4299-13 Rack
Mount Kit)
8
FA-274
Cage nut (part of the Model 4299-13 Rack Mount Kit)
4
7709-308
25-pin D-shell connector kit
2
0713411
Safety Precautions
1
CS-1195-8
Eight-pin custom cable connector (refer to Keithley document number
PA-907 for instruction)
4
CS-1196-8
Cable housing (refer to Keithley document number PA-907 for
instruction)
4
Instrument and module serial numbers
Each 2606B has three serial numbers, one for the instrument and one for each module.
The instrument serial number is on a label on the front panel. This serial number is not available
through a remote interface.
The serial numbers for the modules are on labels on the rear panel. The serial number for a specific
module can be accessed through the virtual front panel or by using the
(on page 7-
145) command over a remote interface.
To access the serial number from the virtual front panel:
1. If the 2606B is in remote operation, press the
EXIT (LOCAL)
key once to place the instrument in
local operation.
2. Select the
MENU
key.
3. Use the navigation wheel to scroll to the SYSTEM-INFO menu item.
4. Press the
ENTER
key. The SYSTEM INFORMATION menu is displayed.
5. Scroll to the
SERIAL#
menu item.
6. Press the
ENTER
key. The serial number for the module is displayed.