2606B System SourceMeter® Instrument Reference Manual
Section 2: General operation
2606B-901-01 Rev. B / May 2018
2-53
Start-up configuration
You can specify the 2606B start-up (power-on) configuration from the virtual front panel. Set the
start-up configuration to a previously stored setup (recalled from internal nonvolatile memory) or reset
to the factory default setup.
To select the power-on setup:
1. Press the
MENU
key to access the main menu.
2. Select
SETUP
, and then press the
ENTER
key.
3. Select
POWERON
, and then press the
ENTER
key.
4. Select the configuration to use.
5. Press the
ENTER
key.
6. Use the
EXIT (LOCAL)
key to return to the main display.
Saving user setups from a remote interface
Saving and recalling user setups
Use the
setup.save()
and
setup.recall()
functions to save and recall user setups.
To save and recall user setups using remote commands:
The following example saves the present setup as setup 1, and then recalls setup 1:
-- Save the present setup to nonvolatile memory.
setup.save(1)
-- Recall the saved user setup from nonvolatile memory.
setup.recall(1)
Restoring the factory default setups
Use one of the reset functions to return the 2606B to the original factory defaults. An example of each
type of reset is shown in the following program examples.
Restore all factory defaults of all nodes on the TSP-Link
®
network:
reset()
Restore all factory defaults (note that you cannot use
*rst
in a script):
*rst
Restore all factory defaults:
setup.recall(0)
Restore channel A defaults:
smua.reset()
Reset only the local TSP-Link node:
localnode.reset()